Mazda World Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
trying to pull the code off a 1990 b2600, I have grounded the single wire by the wiper motor and used a paper clip to connect the terminals for the plug next to it. The LED light comes on but does not flash. How am I screwing up?
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #2 ·
fixed it, the battery clamp was bad, that was replaced then you unplug the wire under the dash and plug it into another plug next to it. That turns the light off on the dash
 

·
Registered
1986 Mazda B2000 SE-5 Long Bed
Joined
·
10 Posts
That wire only resets the 60/80k routine service light, it does not pull codes. The CEL will not flash, the wire you ground with should be a test light which will flash.
 
1 - 3 of 3 Posts
Top