Mazda World Forum banner
1 - 2 of 2 Posts

· Registered
2 Posts
Discussion Starter · #1 ·
Hello everyone in the world of Mazda...
Just registered on the forum, and this will be/is the very first thread/post!!
I've just replaced the rear and front bushings on both lower control arms on my MPV, but am having difficulty finding solid information reference torque settings on all bushings, and related bolts/nuts. In particular the plates that hold the rear bushing to the sub-frame (as they tension and help align/set the suspension angle and resistance) and the nut that bolts up from the bushing through the plate to give the correct support. My vehicle is the 2005 - 2009 model and any/all settings should be universal?
VIN : 7AT0C11EX14443458
Chassis: LW3W-443458
Engine No: L3-755525
These settings are critical to the correct configuration and need to be torqued to ensure everything is at the correct and the same/equal tolerance.
Would greatly appreciate any information and the torque charts if anyone has them or can point me in the right direction?
Thanks in advance for your help...

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.