Mazda World Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
On my 2.5 one of the bolts holding the EGR onto the back of the engine snapped, leaving the remnants in the block. I'd be real careful if I were you.
 

·
Registered
Joined
·
1,409 Posts
Thanks for the advice. Cleaned EGR but idles rough/stalls when EGR vacuum is reconnected. I need to check again if EGR holds vacuum.
you might have bigger problems than you think. is it throwing any codes? there are 2 solenoids that control egr actuation, these solenoids are controlled by the pcm. they are only available as a set, and kinda pricey. it gets worse.
 
1 - 4 of 4 Posts
Top